The soffits didn t appear to be congested with insulation however the ridge vent had a filter in place.
May lead to delamination of the roof sheathing.
Particularly on the roof.
The attic was vented by soffit and a ridge vents.
The horizontal board enclosing the ends of the rafter projections or tails is normally referred to as the board.
It may be mfgr.
To improve it make sure your home has continuous ridge and soffit ventilation.
What is the spacing requirements between the insulation and the roof deck sheathing at the location of the vent.
This winter i went up.
Delaminations commonly affect single ply and fully adhered roofs.
But probably not due to the amount of delamination.
3 8 plywood roof sheathing.
Defects in those sheets or it could be that the ventilation was blocked only at those sheets.
High moisture levels break down the glue in the plywood and allow the plies to delaminate.
Between the years of around 1964 to 1975 homes being built saw the installation of what was first generation fire retardant plywood.
What might delamination of the roof sheathing lead to.
That being said what the home inspector saw may or may not be mold.
Roof decking plywood delamination if you have a home twenty five years or older you may want to consider the condition of the plywood.
Like blisters delamination can come from improper installation in inclement weather.
First deal with the cause which is inadequate attic ventilation.
In the attic the roof sheathing appears to be delaminating and some staining was observed.
If the environment is humid moisture can get trapped between the membrane and insulation.
Incidental roof leaks particularly ones that go unnoticed can delaminate plywood sheathing or cause osb to swell.
One of the implications of high moisture levels from either condensation or leakage is delamination of plywood sheathing.
It was plywood and had delaminated.
In determining if it is.
The contractor thought it might have been due to excess moisture in the attic.
When the membrane and insulation separate.
This is sometimes accompanied by buckling.
If this is the case the solution is twofold.
Leaks around deteriorated flashing are the most common.
Depression between the rafters.
I had my roof sheathing replaced a year ago.
This may be indicative of what.
The worst cases result in patches of rot.
Panel type roof sheathing may lift off the rafters in a regular pattern.
De lamination of the roof sheathing may cause.