01 door lock motor and switch assembly.
Maytag 4000 washer door locked.
Once the washer door is closed the washer can begin operating.
The door locked but did not start yet.
The door may immediately unlock.
If the washer was powered on before being connected to water the door may be locked and it may go into a drain mode.
If the washer has an f8 e1 error or lo fl error the door will be locked and the control will be unresponsive.
The door lock can fail either mechanically or.
The door lock will not open now.
Ok you will need to remove the lower front panel and reach up inside the unit on the right side of the door to manually unlock the door then try to run any cycle and see what it does.
In this scintillating safari into front load washer wasteland samurai appliance repair man shows you how to manually unlock the door on a front load washer.
If nothing else works the washer door can be opened as follows.
I decided to cancel and turned the power off.
The washer will go into a hold and drain routine for 8 minutes.
If the door lock is defective the washer door will not latch properly.
First check that there is no water left in the machine.
I started the machine.
This is a guide about unlocking the door on a maytag front load washer.
During this period you will be able to hear the pump running.
Maytag washer door or lid won t lock.
I have a maytag 4000 series 4 5 cu ft.
After 8 minutes the door will unlock.
The washer door cannot be opened with the key button if power is off.
The door lock led light will blink.
I tried to push cont read more.
The door lock secures the washer door shut during operation.
Nothing else will appear to be happening with the machine during this time.
Ask your own appliance question.
The door should unlock after 60 seconds.
Pausing the wash cycle is how it can be disabled.
If there is any water left and you are unable to run the drain programme empty the machine by detaching the drainage hose.