Hello my name is the handle is just loose then there are set screws on the back side of the handles that you can tighten.
Maytag freezer door handle loose.
The setscrews might have only been partially tightened when the handles were installed.
To do this grip the handle securly and yank the handle straight to the left and it will unclip and pull off.
How do i get to the screws holding it.
Place the new handle on the door for side by side doors the small screws should face the other door and ensure that the top and bottom of the handle is placed over the screws in the door.
Once both screws are loose pull the damaged refrigerator handle off of the door to install a new handle.
If you need further instruction i am here.
Test the handle tightness by opening and closing the freezer door a few times.
The handles are installed by the owner or installer as directed in the installation instructions.
This video provides step by step repair instructions for replacing the freezer drawer handle on a frigidaire refrigerator.
However if the handle is loose closer to the door you have to remove the handle and tightened the screws you see when the handle is removed.
Carefully twist the door handle and gently pull it away from the freezer.
The handle on the bottom freezer door is becoming loose how do i tighten it.
If either the refrigerator or freezer handle is loose or not tight against the door they might not have been installed correctly.
Ask your own appliance question.
If your bottom freezer refrigerator handle is loose making noise or even falls off after use it was not installed properly by the owner or installer.
If the handle is still loose tighten the screws on the handle to fully secure it.
Check the setscrews per the instructions below.
Download a copy of the installation instructions.
Once the handle is pulled off you can tighten the screws going into the handle bracket on the freezer door and you should be good to go again.
It is a maytag ice20 french door bottom freezer.
Order a new freezer door handle here and install it the same way the old one was removed.
Firmly push the handle onto the door.
There is a lot of force needed to unclip the handle.