If the control locked light will not turn off i recommend unplugging the washer for 5 minutes.
Maytag front load washer door locked light flashing.
So the first thing you ll want to do is just unplug the washer for 60 seconds and see if the latch will reset.
Reconnect power to washer plug in.
The door may immediately unlock.
The lid will lock and the machine will enter a pump out mode for 8 minutes.
This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
To unlock the controls press and hold the cycle end signal for 3 deliberate seconds or until the control lock light goes out.
When the lock light is blinking it typically means that the unit either took to long to fill with water in which case it ll go into flood mode and keep draining for 15 20 minutes and unlock on it s own or there is a glitch in the electronics and just unplugging it for 60 seconds will reset the issue.
This happened when i forgot to turn the water on.
If not i recommend calling a service technician to diagnose and repair the washer.
After plugging the washer in one of the following 3 events will happen.
When using one of these cycles the door will remain locked until the cancel button is pushed.
The door should unlock after 60 seconds.
First it had a code blinking that i looked up and it was for the water so i turned it on and now it is making a humming noise and the door is locked and that is all it will do.
Tyler z home appliance technician replied 2 years ago.
Wait approximately 2 minutes for control to reset.
The washer will go into a hold and drain routine for 8 minutes.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
Run a drain and spin cycle.
Wait approximately 2 minutes for control to reset.
If the washer does not unlock at the end of a wash cycle unplug the appliance or disconnect power.
Nothing else will appear to be happening with the machine during this time.
You could have a failed control console or a bad electronic control board in the washer.
The door lock light is blinking on my front load maytag maxima.
If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor.
This is a page about unlocking the door on a maytag front load washer.
When using one of these cycles the door will remain locked until the cancel button is pushed.
Our maytag maxima steam washer has a flashing yellow light our maytag maxima steam washer has a flashing yellow light next to door locked the door won t open and the machined cannot be turned on.
This is all it will do.
